To chop a connector or reverse engineer it's mate
in Making on September 9, 2018 | 3D Printing Electronics Soldering Desk Lift Fusion 360
I ordered a power supply for stepper motor power to use in the Desk Lift project. It came with an interesting connector I’ve never seen before.
I almost cut the connector off and started soldering but then I thought better of it.
I iterate a bit too much…
Your comment has been submitted and will be published once it has been approved.
Your comment has not been submitted. Please go back and try again. Thank You!
If this error persists, please open an issue by clicking here.